Cute Ghost Laser Cut UV Print Tutorial

Getting these pocket ghosts to come out right was quite the process. First you need to find your art and make sure it's okay to use it commercially if you plan to sell the products you make with it. We found these cute ghosts on Canva and then found the corresponding files on Etsy and purchased the download that allows us to use it commercially.

The first step is to put your files into the EufyMake  software. The program is pretty forgiving, accepting many file types. We used jpegs.

To get the see-through ghost effect, we used clear 1/8" acrylic. Put the clear acrylic on the print bed, masked side down. It will make it easier to cut the ghosts out later if you don't remove the masking from the back of the acrylic at this stage.

Since you will be printing on the back of the acrylic, you'll want to put your color layer down first, and then the white layers. Here are our settings.

After these have printed, move the acrylic sheet to your laser bed. We used our XTool P3 laser which is great for cutting acrylic. 

You'll need to import the same picture files into the XTool software that you did into the EufyMake program. Once those are on your screen, offset each ghost so you have an outline. Set the outline to cut.

You can either delete your colored ghost jpegs or set them so that they are not printed.

Your laser will take a snapshot of the acrylic you have put inside. Align your cutouts with the pictures of the ghosts you printed. This is the tricky part. You'll have to eyeball it. They don't need to be perfect, but you don't want to lose any of your printed ghosts either. You can see some of the ghosts below weren't aligned just right.

For our laser and the acrylic we chose, we set the power to 80% and the speed to 10 mm/s. It cut straight through, no problems.

Pull your cuts out of the laser and peel the backing off and you'll have your ghosts all ready to put magnets on or to just have in your pocket for safe keeping. Let us know if you have any questions.

                                    Front                                                                Back

 

                                            

Make a Pumpkin Patch Sign on Your xTool Laser

We started this project in Canva, saved it as an SVG and then imported it into xTool Studio. We couldn't get our image just right, so we adjusted it in LightBurn and then imported it into xTool's software again. This worked great, even though it took a little longer than we had hoped.

Next, we put our pre-measured wood into the xTool P3 and made sure our design was the correct size.

From there, we chose our material from xTool's prepared list. We chose 1/4 inch plywood. It didn't matter too much since we were just engraving and not cutting. Remember to remove the cone from the xTool P3 laser before you engrave. You get a cleaner burn that way.

The first pass wasn't deep enough, so we did it one more time and liked it better.

We wanted to stain the sign and started by using a honey-colored stain and let it dry.

Since it wasn't exactly what we wanted, we did our second coat with a darker stain and then added some color with paint markers. You need to have a steady hand when you do this.

Here's our sign in its own little pumpkin patch. Let us know if you have any questions in the comment section.